1.0mm-80mm POM Delrin polyformaldehyde PP Polypropylene PA Nylon PTFE PEEK plastic ball

Materiale

DELRIN Balls (ACETAL RESIN-POM)

Dimensione

Φ2.381mm—Φ38.1mm

Grado

G0-G3 (±0.01-0.05mm)

Densità

Intorno a: 1.4g/cm3

Caratteristica

Prestazione: it is similar to nylon, but slightly harder than nylon, slightly larger than the density recommended products applied to the required low water absorption

Applicazioni

POM ball table and drawer slide device is typically used, bearings, rollers, valves, and electronic apparatus, sailing apparatus.

Materiale

Polypropylene Balls(PP)

Dimensione

Φ2.381mm—Φ38.1mm

Grado

G0-G3 (±0.01-0.05mm)

Densità

Intorno a: 0.85g/cm3

Caratteristica

Has good resistance, chemical resistance, low density (density less than water), low water absorption, the highest melting point of the thermoplastic with excellent electrical insulator and low dielectric coefficient, often used for floating capacity requirements, withblood transfusion, level calibration indicator. It has a high resistance to chemical substances, such as acid, alkali, alcohol, many inorganic substances, salt solutions, solvents, gasoline, acqua, olio, grease, cleaning agents, fruit juices, milk and the like, but not resistant to aromatic carbon hydrogen compounds and chlorate…….

Applicazioni

PP ball is mainly used for transfusion, level calibration indicator.

Materiale

Nylon Balls (Zytel®, Polymide–PAPÀ)

Dimensione

Φ2.381mm—Φ38.1mm

Grado

G0-G3 (±0.01-0.05mm)

Densità

Intorno a: 1.1g/cm3

Caratteristica

The nylon has preferably the alkali metal, to adapt to the neutral characteristics of petroleum products and all kinds of chemical products.

Applicazioni

Used in check valve, light load, the knob pull switch, low-cost, but also for better flexibility requirements, high hardness aspects

Materiale

Teflon Balls-PTFE

Dimensione

Φ2.381mm—Φ38.1mm

Grado

G0-G3 (±0.01-0.05mm)

Caratteristica

Based frictionless known material having excellent chemical stability, resistance to corrosion, sealing, high lubricity non-tackiness, electrical insulation and good anti-aging Stamina. Continuous use temperature range of
-180 ° C to 250 ° C. PTFE (Teflon ®), ball so excellent frictionless known to most corrosive resistant possessed electrically insulating material,

Applicazioni

Particularly suitable for use in cryogenic liquids and acids under the conditions of the instrument.

Materiale

PEEK

property

High tensile

High temperature resistant

High abrasion resistant

High fatigue resistant

Environmentally friendly

Chemical stability