إل&R 10kV~24kV Porcelain Drop-out fuse cutout

Drop-out fused cut out and load Switching fuse cutout are of outdoor used high voltage protective device.To

be connected with incoming feeder of dأناstribution line it mainly protect transformer or lines from short circuit

and overload,and on/off loading current.

Drop-out fused cut out is com-posed of insulator supports and fuse tube, static contacts is fixed on two sides

of insulator support and moving contact is installed on two ends of fuse tube. Fuse tube is composed of inside

arc-estinguishing tube, outer phenolic compound paper tube or epoxy glasس tube,Load switching fuse cutout

provides enforced elastic auxilأناary contacts and arcextinguishing enclosure for switchinز on/off loading current.

At normally working via fuselink tightened the fuse tube is fixed to form up of close position.In case system

occur faults, fault current result in fuse melt immediately and take place electric arc, which let arc-extinguishing

tube being heated and ex-plode a lot of gas. This will produce high pressure and blow off the arc along with tube.
After fuselink melt moving contact has no tightened strength again, mechanism is locked and fuse tube dropout.

Cutout now is in open position.When it needs to switch off during cut out loading. operator shall via insulating

operating bar pull the moving contact, في its beginning main contact and auxiliary static contact is contacted sill.
Whiling pulling the auxiliary contact is separated between auxiliary contacts there occur electric arc and the arc

إرادة be lengthened in arc-extinguishing enclosure gap and meanwhile arc- extinguishing explode gas to blow off

the arc during current passing zero.

Technical specification